The smart lock, which had been used for two years, is replaced with the successor to Sesami 4.Waiting time zero is super convenient

Installation and setting of sesami 4

　Sesami 4 is a product following Sesami MINI and Sesami 3.Although the appearance looks almost the same, especially the part that controls the thumb turn has been improved/strengthened, such as lowering the failure rate and noise and increasing the strength.The shape/dimensions of the main unit are probably the same, so if you are a existing user, you should be able to attach it in the same way.

セサミ4(黒)とセサミMini(白)裏面。下の部分をサムターンにあてがう側面パッケージの中には本体以外に、説明書、予備の両面テープ、本体の取り付け嵩を増すためのアダプタ、サムターン部分の調節ねじ用のドライバーが入っている

　First, open the lid of the battery box of Sesami 4, extract the battery insulation sheet, and restore the lid.Before peeling off the protective sheet of double -sided tape, turn the sesame 4 on the door of the door with a hand and fix it, and check if it works without catching.If there is no problem, peel off the protective sheet and fix it with double -sided tape to that position.

電池ボックスの蓋を開け、電池の絶縁シートを抜き取る手で固定して、引っかかりなくサムターンが回るかをチェックした後、その場所に両面テープで固定する取り付け完了

　Depending on the door, the height of the part that rotates the therma 4's thumb turn is necessary to adjust the width, but it was attached without any problems at my house.

　However, after installation, I encountered a problem.

　The next step is to collaborate with smartphones and sesami 4 using apps.Download, install, and start the app from the store.Of course, there is no device, so press "+" on the upper right.Since the detected sesame is displayed, tap it and select it.

　After that, a fine adjustment of the locking position and the unlocking position is performed.The thumb turn is adjusted to the locking position, the app taps "Fix the position of the lock", and then the thumb turn is tapped according to the unlocking position.

セサミアプリ。ちなみに、これも旧式のセサミ用途は違う新しいものになっている初めて起動すると、当然接続デバイスはないので「+」をタップして追加すぐにセサミが認識される続いて、施錠位置と解錠位置の指定を行なう。ただ、後述の通り、実際の鍵の施錠位置とアプリ上での位置が90度ずれていた

　This is ready, but when I used it, I noticed that unlocking and locking were reversed.When the thumb turn is locked, it is unlocked in the app, and when it is turned to a unlocking position, it is locked in the app.

　I thought that the opposite was tapped by fixing the position, so I put the physical key to the locking position and tap "Fix the locking position" again.I couldn't change it.I thought that it was 90 degrees different at the time of installation, so I peeled off the double -sided tape and checked it, but I did not make a mistake.

　After that, if the trial and error showed that the recognition of the locking position and unlocking position in the application were reversed, the locking position was turned 30 degrees instead of changing each at once, and the unlocking position.By shifting the place by chasing the two with the feeling of rotating 30 degrees, the angle could be changed by 90 degrees.

　This problem can be avoided by specifying the position from zero, rather than determining the default unlock/locking position, so I would like to improve the application.

　Other than that, there was no particular problem.